NOTE: While repeating the setup process, when you’re prompted to pull the battery tab use a small tool, such as a micro screwdriver, to carefully remove the coin cell batteries from the casing of your Panic Button, then reinsert them. Now, re-add the Panic Button to your alarm system by tapping on Set Up a Device from the main menu and following the onscreen instructions.The Ring app will confirm that your Panic Button has been successfully removed.Press and hold the pinhole reset button using the end of a paperclip or similar tool. Holding the Panic Button in one hand, use your other hand to carefully twist and remove the back cover.From the Panic Button’s dashboard tap Device Settings (gear icon), then tap the Remove button.Select the Panic Button you wish to remove. In the Ring app, tap the main menu, then tap Devices, then tap Alarm or Alarm Pro Base Station.You might have to remove your Panic Button and then re-add it to your Ring Alarm. Still Won’t Connect? Remove then Re-Add Your Panic Button If it blinks red once, it is unable to communicate with the Base Station.If it blinks green once, it is connected and communicating with your Base Station.If it blinks green three times, it is ready to connect to the Base Station.Open the cover (see pic below) and briefly press the button on the front of the device (do not hold it down because this could trigger the panic alarm).The Range Extender helps extend and expand the Base Station’s Z-Wave network, allowing for greater range and signal strength for all compatible devices at your location. Add a Range Extender between the Panic Button and the Base Station.Move the Panic Button closer to the Alarm or Alarm Pro Base Station.If Your Panic Button (2nd Generation) Won’t Connect Having issues with your Ring Alarm Panic Button (2nd Generation)? Follow these troubleshooting steps to help resolve them.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |